S70 L5-2.4L VIN 61 B5244S (2000)
Connect the connectors for the heated oxygen sensor (HO2S) to the wiring at the rear edge of the transmission.
Secure the heated oxygen sensor (HO2S) wiring at the rear engine mounting (2 mounting points).
Finishing
Install
-
the air preheating hose between the heat deflector plate and the air cleaner (ACL)
-
the engine stabilizer brace between the suspension turrets.
-
the front exhaust pipe on the manifold and three-way catalytic converter (TWC). Use a new gasket and new nuts. Lubricate the threads with paste
116 1408. Tighten the nuts. Tighten to 25 Nm.
WARNING: Avoid skin contact with the paste.
-
the rubber mounting for the rear exhaust system
-
the front SIPS member. Tighten to 25 Nm
-
the brake pipe on the plastic holders at the front SIPS member
-
the support bracket between the cylinder block and the manifold and three-way catalytic converter (TWC). Tighten the screws
-
the heat deflector plate above the coolant pipes and hoses
-
the right drive shaft.
