volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Fault-Tracing Information|Page 9784 > < Fault-Tracing Information|Page 9782
Page 2
background image

Check relay 212 (2/5).

When the seat-belt reminder is activated, a ticking sound can be heard from the relay. If no sound is heard, this means that the relay has become stuck
again, in which case it should be replaced.

-

Ignition off.

Check relay 212 (2/5) #5 for a short circuit to ground, as described in See: Restraint Systems/Air Bag Systems/Testing and Inspection/Component Tests
and General Diagnostics/Component Tests and General Diagnostics/Checking Wiring and Terminals - Permanent Faults 
 
Do the necessary corrective action.

After performing this procedure, See: Verification 

Checking the Wiring - II

Checking The Wiring

-

Ignition off.

-

Disconnect the control unit connector.

-

Ignition on.

Check the wire between control unit connector #34 and relay 212 (2/5) #6 for an open circuit, as described in Checking wiring and terminals -
Permanent faults
.

Check the ground wire for relay 212 (2/5) #2 for an open circuit, as described in Checking wiring and terminals - Permanent faults.

See: Restraint Systems/Air Bag Systems/Testing and Inspection/Component Tests and General Diagnostics/Component Tests and General
Diagnostics/Checking Wiring and Terminals - Permanent Faults 

Do the necessary corrective action.

Additional information

Fault-Tracing Information|Page 9784 > < Fault-Tracing Information|Page 9782