volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Wheel Speed Sensor|Service and Repair > < Diagram Information and Instructions|Page 813
Page 7
background image

^

Pull the cable tight in the cable duct at the right spring strut turret. Use a tie strap.

^

Pull both cables taut in cable duct at the left spring strut turret. Use a tie strap.

Checking ABS system after repair Method 

Note:  It is important that the following checks are made in the correct order.

^

Connect Volvo Scan Tool (ST). Select: MONITOR TEST/ENTER/SCROLLING LIST/ENTER/LIST 1/ENTER/ 

^

Rotate right front wheel.

^

Check signal from right front wheel.

^

Connect left wheel sensor. (Connect connector at left ABS sensor.)

^

Rotate left front wheel.

^

Check signal from left front wheel.

^

Test drive the car.

^

Carry out a brake test.

^

Use the Volvo Scan Tool (ST) to check that there are no diagnostic trouble codes (DTCs). 

Wheel Speed Sensor|Service and Repair > < Diagram Information and Instructions|Page 813