S70 GLT L5-2.4L Turbo VIN 56 B5244T (2000)
Electronic Brake Control Module: Service and Repair
Control module (ABS), replacing
Preparation
Disconnect the battery lead
VCC-104452.
Preparations for replacement
Note: There is no need to download software when replacing the ABS control module.
Remove the air cleaner (ACL) housing
Brake pipe master cylinder / ABS unit, replacing.
Remove the integrated relay / fusebox. Remove the connector for the ABS unit
Brake pipe from hydraulic unit / front wheel /junction, replacing.
Removal
Remove the control module
Remove:
-
the pump motor connector
-
the four screws. Use a 6 mm torx external socket.
Carefully lift the control module.
Check the control module
Check:
-
that the control module is of the correct type (this depends on whether the car is equipped with STC or not)
-
that none of the pins or sockets on the connector are damaged
-
that there are no contaminants on the mating surfaces between the control module and the ABS hydraulic modulator
-
that no part of the control module seals remain on the ABS hydraulic modulator valves.
Installation
Install the control module on the