S70 T5 L5-2.3L Turbo VIN 53 B5234T3 (1998)
CAUTION: Always oil new components, as well as machined surfaces of pump housing, with ATF fluid prior to installation.
NOTE: O-rings/seals must be replaced in all cases. Oil components prior to installation.
Assemble
Tool Required
^
999 5515 Drift
^
999 5184 Drift
^
999 5444 Press Tool
1. Mount bearing on shaft. Support bearing inner race with drift. Press bearing onto shaft, ensuring that it is installed in same position as before.
2. Install O-ring retainer.
a. Remove O-ring if already mounted in retainer.
b. Oil retainer with fluid and tap carefully into retainer seat. Use drift.
3. Install in pump housing:
a. O-ring in retainer.
b. seal in pump housing. Use drift. Tap seal into seat in housing.