S80 L6-2.9L VIN 92 B6294S2 (2004)
Applies to cars with RTI (road traffic information)
-
Take the new CD changer from the kit. Prepare the CD changer according to points CD changer (10 CD) See: CD Changer (10 CD) and CD
changer (10 CD) See: CD Changer (10 CD)
-
Slide the CD changer into the bracket. Secure the CD changer using the four screws from the kit. See the illustration
-
Connect the blue pre-routed connector for power supply to the CD changer. The connector is taped at the left-hand tail lamp
-
Connect the new short DIN cable according to the installation instructions supplied with the DIN cable
-
Position the pre-routed cable under the bracket. Screw the bracket into position using the four screws
-
Fold the side panel back into position.
Finishing work
Applies to cars without RTI (road traffic information)
-
Connect the new routed DIN cable to the radio
-
Connect the other connectors which were disconnected from the radio
-
Reinstall the radio
-
Connect the connectors to the dashboard environment panel. Reinstall the dashboard environment panel
-
Reinstall the panel and gear selector lever boot around the gear selector lever
-
Fold the carpet at the left-hand front seat back into position
-
Reinstall the side panel on the centre console
-
Reinstall the sill trim panel in the left-hand front and rear doors
-
Fold the left-hand front seat back into position
-
Tighten the screws in the front edge of the seat. Use new screws from the kit. Tighten to 40 Nm (30 lbf. ft.). Reinstall the covers over the screws
-
Reinstall the left-hand front side panel in the cargo compartment
-
Install the new left-hand side folding panel from the kit
-
Reinstall the side cushion
-
Fold the backrest back into place
-
Reinstall the seat cushion.
-
Turn the ignition key to position II
-
Reconnect the battery negative lead
-
Reinstall the carpet in the cargo compartment
-
Program the software according to the service information in VIDA.
