S80 L6-2.9L VIN 92 B6294S2 (2004)
-
Position the red/white (R/W) single cable with the smaller cable terminal facing backwards along the cable. Insulate the cable. Secure the cable
using the foam tape from the kit. It must not come into contact with the chassis.
-
Connect the red/white (R/W) cable with the large cable outer terminal to the outer position (1) on the reverse of fuse socket number 10 on the fuse
holder. Remove the decal (2). Carefully pry up the red secondary locking on the face in the end nearest terminal 10. At the same time press the
cable into position.
Hint: If there is a problem inserting the cable, the fuses on the outer side must be removed so that the red secondary locking can be opened wider.
-
Reinstall the decal
-
Install a 10A fuse in fuse socket 10 on the fuse holder.
-
Secure the cable harness at the cable duct. Use two tie straps (1)
-
Secure the cable (which was connected to the fuse holder) at the cable harness for the fuse holder. Use a tie strap (2).
Connection in the fuse holder
Applies to cars from model year 2005- (CH 390000-)
