S80 L6-2.9L VIN 92 B6294S2 (2004)
-
Remove the right-hand side panel. First remove the cover and the screw from the front edge
-
Pull the top of the panel out until the clips release
-
Pull the seat belt out of the holder (1)
-
Remove the safety cover. First bend out the hooks on the underside. Pull the cover straight up
-
Fold the panel inwards. Lift the panel out.
-
Route the cable harness (from the kit) from the cut out for the radio between the front air duct (1) and the stay (2) for the centre console
-
Clamp the cable to the stay. Use the tie strap (3) from the kit
-
Route the cable harness further under the carpet and along the front air duct to the seat mounting member (4)
-
Secure the cable harness at the existing cable harness (5) using the tie strap from the kit.
-
Continue to route the cable under the carpet and under the cable ducts (1 and 2) along the right-hand side of the car towards the cargo
compartment. Ensure that the cable harness is securely pressed down between the sills and carpets
-
Route the cable harness under the existing wiring and the connectors by the cable duct (2).
Illustration A applies to the S60 and the S80