volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Towing Relay Kit, Brake Lamps|Page 19392 > < Towing Relay Kit, Brake Lamps|Page 19390
Page 13
background image

-

Reinstall the support for the floor in the cargo compartment and the floor extension. Tighten the three screws

-

Applies to cars with two rows of seats: reinstall the jack.

Illustration B

-

Connect the routed cable harness to the existing pre-routed cable harness in the space

-

Route the excess cable into the small space and secure to the existing cable harness. Ensure that the connectors are secured so that they do not
rattle

-

Reinstall the drain hose for the battery

-

If the fog tail lamp and/or positive power supply / charge function is being connected for the XC90, continue with point 21. Otherwise go directly
to point 25.

Connecting the fog tail lamp and/or positive power supply / charge function 

Note! To connect the positive power supply / charge function for the XC90, remove the side panel on the left-hand side of the cargo
compartment according to points 21-24.

-

Pull off the rubber strip at the rear edge of the door opening to the left-hand rear door opposite the left C-post panel

-

Carefully pry off the left-hand C-post panel sides at the top using a plastic weatherstrip tool Then pull until the three clips on the inside release. Do
not damage the headlining or the panel

-

Remove the panel by pulling upwards slightly and unhooking it from the side panel.

Towing Relay Kit, Brake Lamps|Page 19392 > < Towing Relay Kit, Brake Lamps|Page 19390