S80 L6-2.9L VIN 92 B6294S2 (2004)
Remove the end piece. See Seat belt buckle end mounting See: Restraint Systems/Seat Belt Systems/Seat Belt Buckle/Service and Repair/Front Seat/Seat
Belt Buckle End Mounting.
Remove:
-
the two screws for the front-rear adjustment motor
-
two plus one screws.
Remove the rail from the bracket and cross member.
Remove the rail.
Installing the seat rail, left hand side
Install:
-
the rail on the bracket / cross member
-
two plus one screws
-
the two screws for the front-rear adjustment motor.
Install the end mounting. See Seat belt buckle end mounting See: Restraint Systems/Seat Belt Systems/Seat Belt Buckle/Service and Repair/Front
Seat/Seat Belt Buckle End Mounting
Install the seat. See Removing power seats, tilting See: Service and Repair/Removal and Replacement.
Note! Removed seat rails must always be checked for movement. Use Vernier calipers to measure from the fixed to the moving component. Both
rails should have the same measurement. If not, adjust one of the rails. If the rails do not have the same measurements the seat does not run
parallel. This leads to increased wear and noise.
Removing the seat rail, right hand side
