S80 L6-2.9L VIN 92 B6294S2 (2004)
-
Adapt the cables up to the grommet. Guide the cables into the hole in the cowl wall.
-
Carefully pull the rubber grommet into position from inside the passenger compartment by pulling in the cable for the passenger compartment
connector socket.
-
Clamp in the electrical cable with the servo pipe using a tie strap (2) from the kit.
Applies to all models
-
Route the cables for the passenger compartment connector socket and the Accessory Electronic Module (AEM).
-
Guide the Accessory Electronic Module (AEM) cable harness down between the carpet and the door sill towards the floor as far as possible. Route
it along the right-hand side of the car, on to the door opening for the right-hand rear door.
-
Route the cable by the right-hand seat mounting on the right-hand seat in the second row of seats.
-
Pull away the mat from the front edge of the right-hand side panel in the cargo compartment.
-
Route the cable on the right-hand side of the air duct towards the front edge of the rear wheel housing. Clamp it in at the air duct using two tie
straps (1) from the kit.
-
Route the cable on the rear of the air duct and out at the front edge of the wheel housing.
Applies to cars with three rows of seats, Illustration A
-
Guide in a wire (1) at the rear edge of the right-hand side panel and along its inside, above the load securing eyelet brackets, and on to the front
edge of the side panel.
Illustration B
