S80 L6-2.9L VIN 92 B6294S2 (2004)
-
Tape the cable harness (2) to the wire and route it on from the rear edge of the side panel.
Applies to cars with two rows of seats
-
Route the cable on the left-hand side of the seat belt's mounting at the front edge of the wheel housing, inside the carpet at the front edge of the
side panel, between the side panel and the rear cargo floor support, to the Accessory Electronic Module (AEM).
Applies to all models
-
Remove the two screws in the Accessory Electronic Module (AEM) bracket and lift up the whole unit. Cut away the tie straps as necessary.
