S80 L6-2.9L VIN 92 B6294S2 (2004)
Install new gaskets on the manifold flanges.
Connect the front exhaust pipe to the manifolds.
Lubricate the threads. Use new nuts. Tighten to 25 Nm.
Press the brake pipe into the clip on the front SIPS member.
Press up and install the front SIPS member. Tighten to 25 Nm.
Install the lower engine cover.
Finishing
Install:
-
the wiring for the heated oxygen sensors (HO2S) using the clip and the clamp
-
the preheating hose
-
torque rod.
Install the servo hose on the torque rod using a tie strap.
Test drive the engine.
Check for leakage.
