S80 L6-2.9L VIN 92 B6294S2 (2004)
Install the large connector on the control module.
Lock the connector using the lock handle above the catch (A).
Install the other connector.
Installing the control module
Move the wiring to the outside of the control module.
Place the control module in the bracket and press it down.
Install the lock plate. Tighten the screw. Tighten to 10 Nm.
Reinstall the side panel.
After consultation with the customer, new software that corresponds to the car can be downloaded. Software for the accessory electronic module must be
downloaded first. Software for the connected accessories must then be downloaded.
Check that no diagnostic trouble codes (DTCs) have been stored during the repair.
Door Module (Power Windows, Power Mirrors, Child Locks, Central Locking), Front Doors
Door module (power windows, power mirrors, child locks, central locking), front doors
Replacing the driver door module (DDM) and passenger door module (PDM)
Preparations
Caution! New software can only be ordered when the control module is installed in the car. VIDA reads off the new control module identity
which is required to order the correct software.
Always check that the control module and control module box connectors do not have bent or damaged terminals or socket / sleeves. This may have been
the cause of the fault.
Removing the control module
This method of removal applies to both the driver door module (DDM) and the passenger door module (PDM).
