S80 L6-2.9L VIN 92 B6294S2 (2004)
-
the drive shaft screw. Use a screwdriver as a counterhold on the brake disc
-
the locating pin holding the brake disc
-
the brake disc.
Slacken off the end of the drive shaft in the hub by knocking the drive shaft into the hub approximately 10-15 mm. Use a rubber or copper mallet.
-
the tie rod ends from the steering arm. Use puller 999 5259 SEPARATOR See: Tools and Equipment/999 5259 Separator.
Measure the position of the wheel spindle and spring strut. See Wheel knuckle / spring strut, calibrating See: Front Steering Knuckle/Service and
Repair/Procedures.
-
both screws retaining the spring strut in the wheel spindle.
