S80 L6-2.9L VIN 92 B6294S2 (2004)
Apply a little automatic transmission fluid on the sensor O-rings.
Install:
-
the pressure sensor
-
the screws loosely (finger tight).
Note! The upper screw is a M10 screw head. The three long screws are M8. The two shiny short screws are self tapping and should go into the
same threads as before.
Tighten the screws lightly crosswise. The tighten to the black screwsto 12 Nm.
Then tighten the two self tapping screws to 8 Nm.
Install:
-
the connector
-
the clip for the cable harness for the pressure sensor.
Installing the transmission side cover
See Installing the gearbox side cover See: Service and Repair/Removal and Replacement/Automatic Transmission Components/Installing the Gearbox
Side Cover.