S80 L6-2.9L VIN 92 B6294S2 (2004)
Headlamp Wiper Arm: Service and Repair
Wiper arm and wiper motor, headlamp, replacing
Removal
Preparations
-
Switch off the ignition.
Headlamp wiper arm
-
Lift up the protective cover over the nut
-
Slacken off the nut a few turns. Leave the nut in place to protect the threads on the shaft journal
-
Remove the wiper arm from the shaft journal. Use a pipe wrench supported against the nut
-
Remove the nut and wiper arm
-
Disconnect the hose.
Headlamp wiper motor
-
Remove the headlamp wiper arm
-
Remove the radiator grille. See Radiator grille, replacing See: Body and Frame/Grille/Service and Repair (-2003) or Radiator grille, replacing See:
Body and Frame/Grille/Service and Repair (2004-)
-
Remove Casing, bumper front, replacing See: Body and Frame/Bumper/Front Bumper/Front Bumper Cover / Fascia/Service and Repair/Casing,
Bumper Front, Replacing
-
Remove Cover strip
-
Remove Shock absorbers
-
Remove Headlamp/bulb, replacing See: Lighting and Horns/Headlamp/Headlamp Bulb/Service and Repair/Headlamp/Bulb, Replacing
-
Disconnect the connector for the headlamp wiper motor
-
Remove the 2 screws from the headlamp wiper motor
-
Remove the headlamp wiper motor.
Installation
Headlamp wiper motor
-
Position the headlamp wiper motor
-
Install the screws. First tighten the inner screw. Then tighten the outer screw. Tighten the screws. Tighten to:8 Nm
-
Connect the connector
-
Install Headlamp/bulb, replacing See: Lighting and Horns/Headlamp/Headlamp Bulb/Service and Repair/Headlamp/Bulb, Replacing