S80 AWD V8-4.4L VIN 85 B8444S (2008)
-
Install the centering tool in one holder.
-
Install the tool on the bumper cover.
-
Hold the holder securely when removing the centering tool. The holder must be installed horizontally and in line with the bumper cover.
-
Repeat points 29-30 until all four holders are in place.
-
Connect the cable harness connectors to the sensors.
-
Install the sensors in their holders. Take care not to release the holders from the tape when installing.
Note! The large gray connector must protrude from the right-hand side of the bumper cover (see image 33).
