S80 AWD V8-4.4L VIN 85 B8444S (2008)
Note! Do not damage surrounding painted surfaces.
-
Remove any swarf.
-
Use holesaw bit, part.no 9997241 (-28.6 mm (1 1/8")), and enlarge the hole.
-
File down the edges of the holes.
-
Remove any swarf.
-
Apply primer part no. 9437350 around the hole edges and allow to dry.
-
Measure for making holes for the rubber grommets in the trunk lid's front right-hand corner according to the diagram and mark out the middle.
-
Pre-drill the hole using a -3 mm (1/8") bit.
Note! Use a 5 mm (3/16 ") drill stop.
-
Drill out the hole to - 8 mm (5/16 ") and then to - 12 mm (15/32 ") to be able to insert the pull screw through for the hole making tool.
Note! Do not damage surrounding painted surfaces.
-
Remove any swarf.
