S80 AWD V8-4.4L VIN 85 B8444S (2008)
-
Locate the four markings at the lower edge of the bumper cover. Enlarge the point in the center of the markings using a scriber.
-
Drill at the markings using a -3 mm (1/8") drill bit. Drill from the inside of the bumper cover.
-
Drill out the holes. Use a -10 mm (13/32") diameter drill bit.
-
Enlarge the holes in the bumper cover using hole cutter P/N 9997234. Place the hole tool's support sleeve on the inside, and the cutting component
on the outside of the bumper cover.
-
Clean the inside of the bumper cover using a mild soap solution.
-
Clean around the holes and the markings using a cleaning wipe, P/N 9192678. Allow to dry.
-
Apply a thin layer of activator, P/N 8637076, to the cleaned surfaces. Allow to dry for at least 10 minutes.
