S80 AWD V8-4.4L VIN 85 B8444S (2008)
-
Take the cable harness and insert the short cable with the rubber grommet into the hole in the cowl panel.
-
Press the rubber grommet into the hole.
-
Now route the shorter of the cables to the right-hand side, along the edge of the fender liner and along out to the front edge of the sill. The long
cable is routed up to the right-hand side of the engine's valve cover.
-
Do not press the cable with edge clips in the wheel housing's panel flange yet.
Image A applies to five cylinder engines, image B to six cylinder engines, image C applies to eight cylinder engines
-
Now route the remaining cable up towards the engine's valve cover/intake pipe on the right-hand side.
-
Route it behind the existing cables and pipes by the cowl panel, up towards and across the valve cover/intake pipes, continue under/along the
cables there and down to the left fender liner.
-
Clamp as illustrated using two tie straps from the kit. On six cylinder engines, the cable is clamped with five tie straps.
