S80 AWD V8-4.4L VIN 85 B8444S (2008)
-
Connect the two five pin connectors to the loose cable ends by the rubber grommet:
Note! The numbers that indicate the different positions are on one side of the connector where the cables go in and are extremely small so
take care when reading them off.
-
Pos 2 Red (R) cable
-
Pos 4 Black (SB) cable
-
Close the connector's catches.
-
Connect the connector (1) in the cable from the rubber grommet to the corresponding connector (2) from the courtesy lighting.
-
Clamp in the cable harnesses at the existing cable harness using tie straps from the kit.
-
Fold the insulation panel and carpet back.
Illustrations A and B
-
Connect the remaining cable connector (1) to the courtesy lighting.
-
Reinstall the panel under the glove compartment.
