S80 AWD V8-4.4L VIN 85 B8444S (2008)
-
Connect the existing grey 2-pin male connector (1) to the grey 2-pin female connector (2) in the pre-routed cable harness.
-
Clamp the excess cable (3) and fuse (3) with cable ties from the kit.
-
Connect the ground lead to the existing ground terminal. Tighten the screw. Tighten to 10 Nm (7.5 lb ft).
Applies to cars with parking assistance camera (PAC)
-
Disconnect the gray male connector from the control module. Connect it to the 2-pin male connector on the cable harness. Connect the remaining
connectors to the control module. Clamp the fuse and any excess cable as previously.
-
Clamp the pre-routed cable harness at the existing cable harness with four cable ties from the kit.
If there is no cable harness to secure to, tape up the new cable harness.
-
Connect the connector to the power outlet.
