S80 AWD V8-4.4L VIN 85 B8444S (2008)
Remove:
-
the connectors, x2
-
the bolts, x4
-
the Engine Control Module (ECM).
Installation
Installing the Engine Control Module (ECM)
Note! Ensure that the rubber seal is positioned correctly in its groove.
Install:
-
the Engine Control Module (ECM)
-
the bolts, x4
-
the connectors, x2
-
the cover
-
the battery's negative cable in accordance with: Battery, disconnecting See: Starting and Charging/Battery/Service and Repair/Procedures/Battery,
Disconnecting.
Ordering software
Order applicable software. See: Testing and Inspection/Programming and Relearning
Finishing
Check that no diagnostic trouble codes (DTC) have been stored in the control module during the repair.
Test drive the vehicle and check the function of the engine.