S80 AWD V8-4.4L VIN 85 B8444S (2008)
-
Locate the four markings at the lower edge of the bumper cover. Enlarge the point in the center of the markings using a scriber.
-
Drill at the markings using a -3 mm (1/8") drill bit. Drill from the inside of the bumper cover.
-
Drill out the holes. Use a -10 mm (13/32") diameter drill bit.
-
Enlarge the holes in the bumper casing using hole cutter part no. 9997234. Place the hole tool's support sleeve on the inside, and the cutting part
on the outside of the bumper casing.
-
Clean the inside of the bumper cover using a mild soap solution.
-
Clean around the holes and the markings using a cleaning cloth, part no. 9192678. Allow to dry.
-
Apply a thin and uniform layer of activator, part no. 8637076, to the cleaned surfaces. Allow to dry for approx. 10 minutes.
