S80 AWD V8-4.4L VIN 85 B8444S (2008)
-
Take locking sleeves, screw, nut and washer from the kit.
-
Connect the cables in accordance with the following:
-
Cable (1) from the engine block heater.
-
Cable (2) joint cable to the passenger compartment connector socket.
-
Cable (3) from the front engine block heater socket.
-
Press the cables firmly into the junction connector and press the locking sleeves in over the cable splices.
-
Tighten the junction connector into the subframe in the existing hole with screw, washer and nut. The washer must be located between the junction
connector and the subframe.
-
Route the cable for the passenger compartment connector socket along the existing cable to the engine block heater.
-
Clamp the cable opposite the existing clamps using three black tie straps from the kit.
-
Route the cable on the rear of the power steering by the pipes that lead to it. Route it along the whole power steering to the right and let it hang
down.
Illustrations A and B
