S80 AWD V8-4.4L VIN 85 B8444S (2008)
PN 9511027, 3M DP8005 adhesive (good for up to 5 cars)
PN 9512950, Glue gun
PN 1161730, nozzle for special tool
PN 31201148, rear subframe bushing
Alternative adhesive: "LORD 305", a general purpose, medium viscosity, two-part epoxy, often found in USA.
SERVICE:
Use the Chassis Ears toolkit to verify that the noise is coming from the bushing. If a metallic knocking noise can be heard from the bushings, replace the
rear bushings and apply adhesive between the subframe tube and bushing.
The recommended adhesive is 3M DP8005 two-part epoxy. See Photo 2 "TJ 17385 -3" in the attachment.
Note!
If properly glued, the adhesive increase the joint strength by approx. 50-100%.
Important!
Let the glue set properly before the subframe is installed in the car. Refer to the recommended time on the glue tube.
Important!
There have been some reports regarding difficulties with removing the existing bushings from the subframe following the previous VIDA procedure. It is
important that the removal socket is installed in the correct way, with the small hole in the socket facing the subframe. Refer to Photo 3 "TJ 17385 -4".
VOLVO STANDARD TIMES GUIDE (VSTG) INFO:
Operation number 99400-2 - General check/adjust acc. to TJ - 0.1 hrs
Operation number 21824-2 - Bushing subframe replace (1 bushing) - See VSTG
Operation number 21825-3 - Bushing Subframe replace (additional bushings) - See VSTG
Operation number 99521-2 - Chassis Ears, inst/rem. (only if Chassis Ears are used in the fault tracing) - 0.4 hrs
- Claims may be submitted under the new car warranty when there is a documented customer complaint using claim type: 01
- Labor times are valid at the time of release and are subject to change.
