S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
An engine speed (RPM) display. The signal is between 0 and 8000 rpm and comes from the engine control module (ECM).
Vehicle speed, value
The vehicle speed can be read off. The signal comes from the Brake Control Module (BCM) or the transmission control module (TCM) via the Control
area network (CAN).
Brake fluid level, value
The sensor is directly connected to the driver information module (DIM).
Indicates whether the control module interprets the signal as low or high level.
Parking brake, value
The sensor is directly connected to the driver information module (DIM). Indicates whether the control module interprets the signal as activated or not
activated. With the parking brake applied the sensor is activated.
The SRS indicator lamp status, value
The Driver Information Module (DIM) informs the Supplemental Restraint System Module (SRS) if the indicator lamp is working or is defective.
Cruise control, value
Indicates whether the cruise control status is on or off.
Description of the customer parameters in the driver information module (DIM)
Total mileage, value
Measurement range 0 - 999999 km, 0 - 999999 miles. The parameter can only be programmed once before the read off mileage exceeds 500 km or 310
miles. Programmed by the Central Electronic Module (CEM) after the control module has been replaced.
Distance conditions for service, value
Indicates the mileage required to display the service indicator message. The available values for metric calibrated instruments are 5000, 7500, 10000,
12000, 15000 or 20000 km. The available values for imperial calibrated instruments are 2500, 5000, 6000, 7500, 10000 or 12500 miles.
Time conditions for service, value
Indicates the time required to display the service indication message. The values set are 6, 12, 18 or 24 months.
Engine run time conditions for service, value
Indicates the time the engine must have been running before the service indication message will be displayed. The value set is 500, 750 or 1000 hours.
Displaying zeroes, value
Setting the instrument panel to display or not display the zeroes.
Temperature unit, value
The temperature unit of measurement can be selected. The temperature display can be selected between Celsius or Fahrenheit.
Unit trip computer, value
Setting the trip computer (applies only to cars with trip computer). It is possible to select liters, Imperial gallons or US gallons.
Clock position, value
12- or 24- hour display.
Mileage at service, value
Reading off the mileage at service. The parameter can be programmed between 0 - 999999 km or miles. When resetting the service reminder indicator
(SRI) the parameter is reprogrammed by copying the mileage.
CAUTION: Mileage at service should be used with total mileage to determine whether a service is due
Time at service, value
Reading off global time at service. The parameter can be between 0 - 163 months (13.6 years). When resetting the service reminder message, the
parameter is reprogrammed by copying the global time in the central electronic module (CEM) to the driver information module (DIM).
CAUTION: Time at service and global time should be used with time conditions to determine whether a service is due.
Engine hours since service, value
Parameter read off. Indicates how many hours the engine has run since the last service. The parameter can be between 0 - 65536 hours. Resets when
service reminder message is reset.
CAUTION: Engine time since service should be used with engine hours to service to determine whether a service is due
