S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
Lamp low fuel level, value
Activating the instrument lamp.
Downloading Software And Replacing The Control Module
New software can be downloaded into the driver information module. When ordering software, the hardware and the software in the car is compared to
the Volvo central database. If the comparison is OK the software is downloaded to the control module.
If the comparison between the car and Volvo central database does not correspond, the database is updated with the configuration of the car. The
software download then begins.
The driver information module is integrated in the combined instrument panel. When replacing the control module the entire combined instrument panel
must also be replaced.
The language in the combined instrument panel can be changed. This is done by ordering new software for the driver information module from the
replacement parts catalogue. In the replacement parts catalogue there is software for reloading the driver information module (reloading driver
information module) and software for changing to 15 different languages. Reloading reloads the same software that was installed before the control
module was replaced.
There are other functions for the combined control module which can be ordered. However, these are not downloaded into the driver information module
but into the central electronic module. There are functions such as the trip computer.
A number of customer parameters can be programmed into the driver information module.
The following data can be programmed into the driver information module. Programming:
-
Conditions for the service reminder indicator (SRI) to light, mileage, time and engine hours
-
If the instrument panel should display zeroes for the mileage
-
Unit for temperature. Fahrenheit or Celsius
-
Unit in the trip computer (only applies to cars with trip computers). Fuel consumption can be displayed in liters per 100 km, miles per GB
Gallon, miles per US Gallon and kilometers per liter
-
12 or 24 hour clock display.
These customer parameters are stored in the control module but not in the Volvo central database. This means that the customer parameters must be
reprogrammed when the hardware is replaced.
