volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Check the Switch for the DVD|Page 15441 > < Check the Switch for the DVD|Page 15439
Page 5
background image

Hint: Certain models of the DVD unit have an extra cable connected to the video input on the DVD unit. This means that there is an extra splicing point
between the DVD unit and the connector to the rear center console locker. Check that the two cables are connected to each other.

Remedy as necessary.

Other information:

-

To access or replace the fuses, see Location of fuses in the rear center console Executive See: Maintenance/Fuses and Circuit
Breakers/Fuse/Locations/Location of Fuses in the Rear Center Console Executive 

-

To fault-trace wiring and terminals, see Checking wiring and terminals See: Testing and Inspection/Component Tests and General
Diagnostics/Checking Wiring And Terminals 

-

For additional information about sound and picture related faults, see Checking the picture on the rear display screen.

Was a fault detected?

Yes - FAULT FOUND

No - No Fault Found

-------------------------------------------------

Checking the picture on the rear display screen

Checking the picture on the rear display screen

Checking the fuses and the power supply

Check that the fuses for the rear display screen and M2D control module are intact and that there is power supply to the fusebox.
The voltage must be approximately 12 V.
The fuses are positioned under the rear center armrest.
Check that the radio is switched on.
Set the mode to TELEVISION using the SOURCE button on the radio.

Checking the M2D control module

Check that the connectors for the M2D control module are connected. See positions 1-5.

Check the Switch for the DVD|Page 15441 > < Check the Switch for the DVD|Page 15439