S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
Was a fault detected?
Yes - FAULT FOUND
No - Checking the TV receiver
-------------------------------------------------
Checking the TV receiver
Check that the connectors for the TV receiver module are connected. See positions 6-8.
Check the supply voltage between terminals #M-7 and #M-15. See position 6.
The voltage must be approximately 12 V.
Check the wiring between the M2D control module and the TV receiver. Check for an open-circuit. Check for a short-circuit to ground. Check for a
short-circuit to supply voltage.
Check the cable terminals on the connector for the TV receiver. The cable terminals must not be damaged, pressed back or oxidized.
Remedy as necessary.
Other information:
-
For information about signals and connectors for the TV receiver, see Signal specification, RTI See: Navigation System/Testing and
Inspection/Pinout Values and Diagnostic Parameters/Signal Specification/Signal Specification, RTI
-
To access or replace the fuses, see Location of fuses in the rear center console Executive See: Maintenance/Fuses and Circuit
Breakers/Fuse/Locations/Location of Fuses in the Rear Center Console Executive
-
To access and replace the TV receiver, see TV receiver, replacing See: Television / Monitor/Service and Repair/Replacing The TV Receiver.
Hint: The above illustration shows the location of the TV receiver on the RTI unit.
-
To fault-trace wiring and terminals see Checking wiring and terminals See: Testing and Inspection/Component Tests and General
Diagnostics/Checking Wiring And Terminals
