S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
-------------------------------------------------
Checking the DC plug
Measure the supply voltage between the metal casing on the outside and the inside of the DC plug connector. See positions E and F.
The voltage must be approximately 9 V.
Check the cable between the DC plug connector and the terminal for the transformer. Check for an open-circuit. Check for a short-circuit to ground.
Check for a short-circuit to supply voltage.
Note! The thin type probe must be used when taking readings from the DC plug. Otherwise the DC plug connector may be damaged or no
reading will be obtained (it will not be possible to connect the probe to the inside of the DC plug connector).
Remedy as necessary.
Other information:
-
To access or replace the fuses, see Location of fuses in the rear center console Executive See: Maintenance/Fuses and Circuit
Breakers/Fuse/Locations/Location of Fuses in the Rear Center Console Executive
-
To fault-trace wiring and terminals see Checking wiring and terminals See: Testing and Inspection/Component Tests and General
Diagnostics/Checking Wiring And Terminals
-
To access or replace the DVD unit, see Replacing the DVD See: Service and Repair/Replacing the DVD
-
To access or replace the cable between the DVD unit and the transformer, see Replacing the cool box See: Refrigerator/Service and
Repair/Replacing the Cool Box
-
For information about signals and connectors, see Signal specification, RTI (road traffic information) Executive See: Navigation System/Testing
and Inspection/Pinout Values and Diagnostic Parameters/Signal Specification/Signal Specification, RTI (Road Traffic Information) Executive.
Was a fault detected?
Yes - FAULT FOUND
No - Checking the cable between the DVD unit and the transformer
-------------------------------------------------
Checking the cable between the DVD unit and the transformer
