S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
Check that the connectors for the transformer and DVD unit are connected. See position 9.
Check the supply voltage from the transformer to the DVD unit between terminals #P1 and #P2, see position 9.
The voltage must be approximately 9 V.
Check the cable between transformer terminal P and the DC plug connector on the DVD unit. Check for an open-circuit. Check for a short-circuit to
ground.
Remedy as necessary.
Other information:
-
To access or replace the fuses, see Location of fuses in the rear center console Executive See: Maintenance/Fuses and Circuit
Breakers/Fuse/Locations/Location of Fuses in the Rear Center Console Executive
-
To fault-trace wiring and terminals see Checking wiring and terminals See: Testing and Inspection/Component Tests and General
Diagnostics/Checking Wiring And Terminals
-
To access or replace the DVD unit, see Replacing the DVD See: Service and Repair/Replacing the DVD
-
To access or replace the cable between the DVD unit and the transformer, see Replacing the cool box See: Refrigerator/Service and
Repair/Replacing the Cool Box
-
For information about signals and connectors, see Signal specification, RTI (road traffic information) Executive See: Navigation System/Testing
and Inspection/Pinout Values and Diagnostic Parameters/Signal Specification/Signal Specification, RTI (Road Traffic Information) Executive.
Was a fault detected?
Yes - FAULT FOUND
No - No Fault Found
-------------------------------------------------
Checking the Sound from the DVD Unit
Checking the sound from the DVD unit
Checking the sound from the DVD unit
Check that the disc in the DVD unit is not scratched or damaged.
Check that the connectors for the DVD unit are connected.
Check that the radio is switched on.
