volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Cable Harness For the Radio (Accessory Electronic Module)|Page 15893 > < Cable Harness For the Radio (Accessory Electronic Module)|Page 15891
Page 28
background image

-

Move the gear selector lever to its rearmost position.

-

Pull the panel (1) with boot rearward and turn as illustrated.

-

Remove the screws (2) from the dashboard environment panel.

Illustration A

-

Angle the dashboard environment panel outwards so that it is possible to insert a couple of fingers between the centre console and the short side of
the dashboard environment panel.

-

Pull the dashboard environment panel downward maintaining the same angle and remove the dashboard environment panel. The panel is well
secured, so some force is required to detach the panel. Unplug the connectors on the reverse side, and place the dashboard environment panel to
one side.

Note! If any of the outer hooks break off, these must be repaired. The method for this can be found in the Workshop Manual in the
section about the dashboard.

-

Remove the screws (1) in the radio bracket.

-

Pull out the bracket with the radio. Pull the lower corner while pressing downwards.

-

Unplug the connectors from the radio and the telephone keypad if applicable, and place the bracket with the radio to one side.

Cable Harness For the Radio (Accessory Electronic Module)|Page 15893 > < Cable Harness For the Radio (Accessory Electronic Module)|Page 15891