S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
-
Remove the blind cover plug (2) and the screw from under the blind cover plug
-
Carefully remove the frame (3) from around the door handle. Use a plastic wedge or similar. Start at the bottom edge
-
Disconnect the door panel (4) by sliding the panel upwards and unhooking the top edge.
Preparations
-
Disconnect the connectors (1) for the door controls and from the existing loudspeaker
-
Carefully remove the moisture inhibitor (2) at the front edge.
Applies to loudspeakers already mounted in the rear doors
-
Drill out the rivets (3) on the existing loudspeaker. Use a 6 mm (15/64") drill
-
Remove the loudspeaker and any rivet swarf from the rivet hole. Also ensure that any remaining rivet sections from the door are removed.
Installation
-
Install the new loudspeaker. Screw the loudspeaker into place using the screws (1) and nuts (1) from the kit
-
Install the moisture inhibitor (2)
-
Connect the connectors (3) to the loudspeaker and the module for the door controls
-
Reinstall the door panel.
Subwoofer and Amplifier For the Subwoofer
Subwoofer and amplifier for the subwoofer
Removing the subwoofer
