S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
1. Remove the screws holding the support for the floor in the cargo compartment at the rear edge.
1. Slacken off the two screws for the floor extension brackets.
Applies to the XC90
Illustration A
-
Route the cable harness from the tow bar socket through the hole in the floor. It may be necessary to remove the spare wheel which partially
obstructs the hole in the floor
-
Adjust the position of the rubber seal (1) so that there is not too much slack in the cable under the car
-
Install the rubber seal in the hole
-
Pull up the floor extension on the right-hand side. Position a shim underneath it
-
Pull up the rear edge of the support for the floor in the cargo compartment. Push the connector into the space behind the right-hand rear wheel
well.
Note! Do not damage the support for the floor in the cargo compartment. It is brittle.
-
Position the cable in the cut-out at the rear edge of the support for the floor in the cargo compartment
