S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
Press the control module up so that the terminal pins connect.
Install:
-
the screws.
Tighten to 1.8 Nm
-
the connector on the control module. Lock the connector
-
the integrated relay/fusebox and the connector for the ABS unit.
-
the integrated relay / fusebox.
Tighten the screw. Tighten to 10 Nm
-
the air cleaner (ACL) housing.
Installing the battery lead
Install the battery cable. See Battery, disconnecting See: Starting and Charging/Battery/Service and Repair/Procedures/Battery, Disconnecting.
Loading software
Note! Switch on the ignition.
Order software according to the table below.
Visual check
Turn on the ignition.
Wait five seconds and until the symbol for the brakes on the dashboard has gone out.
In the event of a fault (the symbol is lit).
Check that the connector is connected.
Function test
