S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
Electronic Brake Control Module: Service and Repair
Replacing the Control Module for ABS and Dynamic Stability and Traction Control (DSTC)
Replacing the control module for ABS and dynamic stability and traction control (DSTC)
Preparation
Disconnect the battery lead
See Battery, disconnecting See: Starting and Charging/Battery/Service and Repair/Procedures/Battery, Disconnecting.
Preparations for replacement
Remove the air cleaner (ACL) housing
See Brake pipe master cylinder / ABS unit, replacing See: Hydraulic System/Brake Hose/Line/Service and Repair/Brake Pipe Master Cylinder / ABS
Unit, Replacing.
Remove the integrated relay / fusebox. Remove the connector for the ABS unit
See Replacing the brake pipe between the hydraulic unit, front wheel and junction See: Hydraulic System/Brake Hose/Line/Service and Repair/Brake
Pipe Hydraulic Unit / Junction / Front Wheel, Replacing.
Removal
Remove the control module
Remove:
-
the pump motor connector
-
the four screws. Use a 6 mm torx external socket.
Carefully lift the control module.
Check the control module
