S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
Engine Torque Strut: Service and Repair
Replacing Cross Stay/Upper Torque Rod
Replacing cross stay/upper torque rod
Removing cross stay/upper torque rod
Remove
-
the torque rod mounting screw in the bracket on the engine.
-
screws at suspension turrets.
-
cross member.
Transferring components
Transfer
-
the brackets on the left and right-hand sides.Do not tighten yet.
-
the torque rod.Do not tighten yet.
Installing cross stay/upper torque rod
Install
-
cross member.
-
screws at suspension turrets. Tighten to 50 Nm (36.9 lb.ft).
-
torque rod mounting screw in the bracket on the engine.
Tighten the torque rod to 80 Nm (59.0 lb.ft).
Tighten the screws between the cross stay and brackets at the suspension turrets to 80 Nm (59.0 lb.ft).