S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
Press the oil pan against the transmission. Tighten the screws (1), (2), (3) and (4). Tighten to 3 Nm.
Tighten the screws (5). First tighten to 25 Nm. Then tighten to 48 Nm.
Tighten all screws in the oil pan joint. Tighten to 17 Nm. Start at the transmission and continue forwards in pairs.
Connect the oil cooler to the sump. Use new O-rings.
Install the screw for the bracket for the fuel line.
Install:
-
a new oil filter
-
the oil plug with a new gasket.
Installing the sub-frame
Lift the sub-frame. Use a mobile jack.
Install:
-
the bracket for the heated oxygen sensors (HO2S) in the rear edge of the sub-frame
-
new screw in the sub-frame. Lubricate the screws
-
the washers at the front edge and the support plates at the rear edge of the sub-frame.
Tighten the screws for the sub-frame. Tighten to 105 Nm.
Angle-tighten 120°. Use bevel protractor 951 2050 BEVEL PROTRACTOR See: Tools and Equipment/951 2050 Bevel Protactor.
