S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
Install new nuts on the ball joints. Tighten to 80 Nm.
Counterhold using a Torx wrench so that the ball joint boot is not damaged.
Install the anti-roll bar links. Use new nuts. Tighten to 50 Nm.
Counterhold using a Torx wrench so that the boot is not damaged.
Install:
-
the screw and nuts for the steering gear. Use new nuts and new screws. Tighten to 50 Nm
-
the front engine pad. Tighten to 50 Nm
-
the torque rod. Tighten the screws through the oil pan. Tighten to 50 Nm. Tighten the nuts in the sub-frame. Tighten to 65 Nm
-
the center screw for the drive shaft. Use a new screw. Counterhold using a screwdriver in the brake disc vents. Tighten to 50 Nm
-
the front air baffle
-
the front wheel.
Removing the lifting beam and the lifting hook
