S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
Install a new cylinder head gasket.
Install the cylinder head. Use new screws.
Lubricate and install all the screws.
Tighten the screws in the order illustrated.
Tighten the screws in the following order:
1. 20 Nm
2. 60 Nm
3. Angle-tighten 130°. Use protractor 951 2050 BEVEL PROTRACTOR See: Tools and Equipment/951 2050 Bevel Protactor.
Installing valve lifters and camshafts
When installing a new cylinder head, the valve clearance must be set. See Valve clearance, setting / adjusting See: Cylinder Head Assembly/Valve
Clearance/Adjustments/Valve Clearance, Setting/Adjusting.
Lubricate the valve guide wells.
Install all the valve lifters.
Caution! Make sure that the lifters end up in the same position as before.
Lubricate the camshaft bearing seats.
Install the intake camshaft. Ensure that the groove at the back of the camshaft is above an imaginary center line
Position the exhaust camshaft. Ensure that the groove at the back of the camshaft is below an imaginary center line.
Applying liquid gasket
