S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
Install:
-
the ignition coils according to the earlier markings
-
the connector for the coolant temperature sensor
-
the connectors for the variable valve timing solenoids
-
the screws for the two ground terminals between ignition coils 1 and 2 and 5 and 6.
Install below the intake manifold:
-
the starter motor
-
the throttle body (TB) connector to the engine wiring
-
the charge air pipe to the throttle body (TB). Tighten the clamp
-
the control hose to the charge air by-pass valve
-
the brake vacuum hose to the intake manifold
-
the bracket and screw to the lower row of screws at the mounting for the intake manifold on the cylinder head
-
the pipe screws at the underside of the intake pipe for the water heated crankcase ventilation. Tighten to 26 Nm.
-
the dipstick pipe onto the intake manifold.
Installing the fuel rail
Install:
-
the fuel rail. Use new screws. Tighten to 10 Nm. Press the quick-release connector for the fuel pressure line until it clicks, see also Fuel line, lock
See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Rail/Service and Repair.
-
the clamps holding the injector wiring and the positive cable to the rear edge of the cylinder head