S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
The function of the trip odometers and the odometer is to display the three available odometer modes. The two settings are the total mileage of the car
and the mileage since the two trip odometers were last set to zero. These two can be reset individually. The odometer and one of the two trip odometers
are always displayed. The central electronic module (4/56) receives a speed signal from the brake control module (ABS) (4/16) which is transmitted on
the high speed section of the Control Area Network (CAN). The central electronic module then transmits the signal on to the driver information module
(5/1) via the low speed section of the Control Area Network (CAN). The distance traveled is saved every fourth kilometer and the value is stored in the
central electronic module (4/56). Press the button briefly to switch between the two trip odometers. Hold the button in longer to reset the trip odometer.
There must be a power supply to the driver information module (5/1) before the odometer can be reset.
Service reminder indicator (SRI)
The service reminder indicator (SRI) lights the first time the ignition is switched on after the service interval has been reached. The service reminder
indicator (SRI) will continue to light and remain lit for 2 minutes, every time the ignition is switched on until it is reset. The service indicator has
changed from model year 2002. The need for a service is indicated partly by a lamp and partly by a text message - "time for service". Previously only
the lamp indicated "Service". The service reminder indicator (SRI) can be programmed in three different ways: distance traveled, time since last service
and engine hours since last service. The service reminder indicator (SRI) can be reset using VADIS or as follows:
Hold down the reset button for the trip odometer and turn the key to position II. Continue holding the button down until the service reminder indicator
(SRI) begins to flash. Release the button.
Engine coolant temperature (ECT) gauge
