S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
Install the cable in the groove on the rubber seal.
Connect the connector.
Install the cover over the level sensor. Tighten to 60 Nm.
Install the backrest. See The backrest See: Body and Frame/Seats/Seat Back/Service and Repair/Backrest
Replacing the Fuel Pump / Level Sensor For the Right-Hand Fuel Tank
Replacing the fuel pump / level sensor for the right-hand fuel tank
Special tools:
999 5720 Wrench See: Tools and Equipment/999 5720 Wrench
Removal
Removing the rear seat
Remove:
-
the backrest. See Backrest .
Draining the fuel system and fuel tank
Drain:
-
the fuel system. See: Powertrain Management/Fuel Delivery and Air Induction/Service and Repair/Draining the Fuel System.
Removing the level sensor / pump
Note! Use special tool999 5720 Wrench See: Tools and Equipment/999 5720 Wrench to remove the snap ring for the level sensor / pump.
Grip the right-hand level sensor and pump holder and pinch it so that the float is held in its lowest position.
Removing the level sensor / pump, continued
