S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
Open the bleed nipple, approximately one turn.
Press in the brake calliper piston to the bottom of the calliper. Use G-clamp as illustrated. Leave the G-clamp in pushed in position.
Press down the brake pedal to the limit position. Keep it pressed down for approximately 2 seconds before releasing it. Repeat this until new brake fluid
enters.
Close the bleed nipple when the brake pedal is fully depressed.
Remove:
-
the hose. Install the protective cap
-
the G-clamp from the brake calliper.
Finishing work, front
See Replacing the brake fluid (using a bleeding unit) See: Replacing the Brake Fluid (Using A Bleeding Unit).
Preparations for replacement, rear
Switch off the ignition.
Clean around the brake fluid reservoir filler cap.
Raise the car
Take out:
-
a collecting bottle and hose to collect brake fluid in
-
a jimmy
-
a large pipe spanner.
Remove the brake calliper
See Brake pads rear, replacing See: Brakes and Traction Control/Disc Brake System/Brake Pad/Service and Repair/Brake Pads, Rear.
Press the piston into the brake calliper
See Replacing the brake fluid (using a bleeding unit) See: Replacing the Brake Fluid (Using A Bleeding Unit).
Install a jimmy bar
