S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
Carefully clean the gasket face and mating surfaces.
Checking the opening function of the thermostat
The thermostat can be tested in warm water.
Maximum opening must occur within 2 minutes in water at opening temperature.
Marking.90° C
Starts to open at.90°C
Fully open at.105°C
Assembling the Belt Drive
Belt drive, assembling
Note! The illustrations in this service information are used for different model years and/or models. Therefore there may be some variation.
However, the essential information in the illustrations is always correct.
Tightening
For tightening torques not in the text, see Tightening torque See: Engine, Cooling and Exhaust/Engine/Specifications/Mechanical
Specifications/Tightening Torque.
Installing the thermostat housing and water pump
Install
-
the coolant outlet pipe on the cylinder head.
Use a new gasket. Tighten to 17 Nm.
-
the rear timing cover. Screw the cover into place at the three mounting points
-
thermostat housing / cable duct. Use a new gasket. Ensure that the coolant temperature sensor cable and cable duct are correctly positioned.
-
the thermostat. Use a new gasket
-
the thermostat cover. Tighten
-
the water pump with new gasket. Apply thread sealant, P/N 11-61 056, to all the screws for the water pump. Tighten alternately.
Installing the oil pump
Use a new gasket and new O-ring around the pump housing.
