S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
-
plugs in inspection holes. Tighten to 20 Nm.
Note! Take care when tightening the plugs for the inspection holes. Do not exceed the torque listed or the threads in the cam cover may
strip.
-
the ignition coils according to the earlier markings
-
both ground terminals
-
the connector for the variable valve timing solenoid
-
the connector for the engine coolant temperature (ECT) sensor
-
engine stabilizer brace. Tighten to 50 Nm
-
ground strip to the engine stabilizer brace
-
the screw for the upper mounting for the transmission dipstick pipe.
Remove tool 999 5755.
Finishing work (B6294S)
Install
-
the trigger wheel. Tighten to 17 Nm.
Note! Ensure that the trigger wheel is correctly positioned against the camshaft.
-
the camshaft position (CMP) sensor housing
-
the clamps that hold the wiring to the rear of the cylinder head
-
the cover over the ignition coils
-
the upper timing cover
-
the engine stabilizer brace. Tighten the screws at the suspension turret. Tighten to 50 Nm. Tighten the screw on the engine stabilizer brace.
Tighten to 80 Nm
-
the covers over the suspension turrets
-
the plastic nuts for the cover in fender liner
-
the right front wheel Installing wheels See: Wheels and Tires/Wheels/Service and Repair.
Finishing work (B6284T)
Install
-
new cover at the rear edge of the intake camshaft
