S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
throttle body (TB).
Remove the pipe between the throttle body (TB) and the charge air cooler.
Remove
-
the screws for the knock sensors (KS)
-
the tie strap at the connector.
Pull the sensors downwards and past the starter motor bracket at the rear edge.
Installing the knock sensors (KS)
Install the new sensors with the screws in the cylinder block.
Route the cables on the outside of the starter motor bracket.
Align the sensor (looking from the front towards the rear). The cable from the sensor for cylinder 3 = 5 o'clock and from sensor for cylinder 5 = 6
o'clock.
Tighten the knock sensors (KS) to 20 Nm.
Press the knock sensor (KS) connectors together. Check that the wiring is in the correct position. Clamp if necessary.
Applies only to B6xx4T
