S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
-
Check that no pins or sockets are damaged on the connector.
-
Carefully press the control module down into the grooves on the inside of the control module box. Press to the limit position
-
Insert tool 999 5722 Wrench See: Tools and Equipment/999 5722 Wrench around the control module.
-
Move the upper section of the tool forwards as far as it will go. Pull up the tool
-
Press the cover into place over the control modules
-
Check that the air ducts are correctly positioned.
Ordering software
Order software according to the table below.
Note! After downloading the software or replacing the engine control module (ECM), the throttle unit must be adapted according to vehicle
communication input: "Adapting the throttle unit".
Finishing
Check that no diagnostic trouble codes have been stored during the repair.
Test drive the car. Check the function of the engine.
